Home > Resources > Knowledges
Search1540 Entries19 Contributors

Limitations of Potential Pulsing on Thick Film Flat Chip Res...

Date: 2019-04-24 22:12:31Posted by: louis.xi

    Surface mount rectangular flat chip resistors are susceptible to failure under some high voltage conditions. In circuitry where there is a possibility of transient potentials, considerable high voltage may be applied to a resistor f...View More

4 Share Collection 1 Comments

Analysis of a DC Converter with Low Primary Current Loss and...

Date: 2019-04-24 22:05:46Posted by: jackiechen0511

This is an open access article distributed under the  Creative Commons Attribution License  which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited . /upload/news/file...View More

6 Share Collection 2 Comments

Selection of Capacitors for DC/DC Converters

Date: 2019-04-24 17:32:33Posted by: Fred

Selection of the output capacitor The following three factors are important when selecting the output capacitor. 1)Rated voltage 2)Rated ripple current 3)ESR (equivalent series resistance)   Of ...View More

6 Share Collection 0 Comments

Solve the problem of VS2010 automatic closed

Date: 2019-04-23 19:46:26Posted by: Xiufang.Ding

VS2010 software can be opened normally and the control can be added  normally ,but when the program is started, VS2010 software will automatic closed. There may be several reasons and solution are given as below. R easo...View More

7 Share Collection 1 Comments

Differential (Normal) Mode Noise and Common Mode Noise

Date: 2019-04-23 17:22:09Posted by: Fred

Conducted emission can be classified into two types. One is "differential mode noise", also known as "normal mode noise". These names are sometimes used selectively depending on the conditions that apply, but here we shall assume they are the same...View More

7 Share Collection 1 Comments

Knowledge about Tantalum Capacitance ---1: Polarity

Date: 2019-04-23 12:47:02Posted by: phoenix.liu@netpowercorp.cn

Tantalum capacitors are polar. One end of the patch tantalum capacitor is marked with a horizontal line, which is the positive pole of the patch tantalum capacitor, and the other end is the negative pole.The longer leg of the lead tantalum capacitor ...View More

6 Share Collection 0 Comments

DOSA--The Distributed-power Open Standards Alliance

Date: 2019-04-23 07:35:43Posted by: Wei

The Distributed-power Open Standards Alliance (DOSA) was established by leading DC-DC converter manufacturers to ensure future product compatibility and standardization within the increasingly fragmented power converter market. The goal of the ...View More

4 Share Collection 0 Comments

Power Supply or Power Converter?

Date: 2019-04-23 05:23:01Posted by: mrpower

Power Supply vs. Power Converter These two phrases fundamentally talk about the same thing – a product that takes one form of electricity (voltage, current and frequency) and convert it to another form to meet the needs of loads. There is n...View More

7 Share Collection 1 Comments